Just got some new ICON 2.0 shocks for the truck and wanted to know what are most guys running and reasons for. Are you running shocks with or without the boots and I think you would run the bodyside up and shafts down on these shocks right. Thanks for your help.
i would put them on just make sure they are sealing crap off the shaft. i wouldnt worry about rusting the icons since they have a lifetime warranty so if they rust out they can be replaced no questions asked :thumb:
only if they sit for a while the bodies tend to rust at the top if you mount them with the body down because stuff sits on the top of them and eats thru
come to think of it arent the icon shock bodies alluminum?
FYI......Icon's lifetime warranty does not cover the finish on the body, nor does Bilstein for that matter.
Most shock shafts are either chrome or nitrosteel.....the chrome ones will pit if they get some good rock chips on them. Nitrosteel is harder than chrome and lasts longer in salt spray tests.
Thanks guys. I'll be leaving them off this time and see how it goes. Truck is going in the shop Monday to get the new shocks installed, ICON 6" blocks in rear, 1" TEI spacer up front, new dynatrac ball joints, and an edge insight. Cant wait to see how much better they ride.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Ford Powerstroke Diesel Forum
5.4M posts
265.8K members
Since 2005
A forum community dedicated to Ford F-series owners and enthusiasts with a Power Stroke diesel engine. Come join the discussion about performance, bulletproofing, modifications, classifieds, troubleshooting, maintenance, and more!