Ford Powerstroke Diesel Forum banner

Fass HPFP

1K views 6 replies 5 participants last post by  vegginpsd 
#1 ·
Which is the one I need? I know i've seen most everyone has a 80psi one, right? What is the model number of it?
Thanks
 
#2 ·
I use the adjustable one: RPFA-1004 I run mine just below 70 psi.

Rover hybrid's has a great price and it's a good way to support a veg company. If they don't have it in stock, usdieselparts.com has a great price, too.

You can save a bit of $$ (maybe $20) by getting a preset one. Rover recommends 75 psi, and I see that many others choose 65 psi.
 
#3 ·
I dont want to change you mind but i have heard of the fass motors dieing. Id look into Airdog
 
#4 ·
Dont worry about a FASS HPFP if installed CORECTLY.
Horizontal installation is the ONLY correct way. The weep hole must by downward. I have installed a lot of HPFP's and I can tell you if done correctly they run a long time. I have removed several and rapaired a few that were not installed correctly. They fail because of being installed incorrectly. When the weep hole is in any other position than downward, it will comprimise the motor seal, and either seize the bearing to the motor shaft, or spin the bearing, ruining the motor armature.

Here is what you need southpaw
FASS Adjustable Veggie Oil Lift Pump

Also check this out
http://www.powerstroke.org/forum/bi...ls-supplements/126785-diy-wvo-components.html

Let us know if you need more assistance.
 
#5 ·
Thank You.
That is a pretty good price compared to DFA's.
I was asking cause I found one for sale on ebay for 250, but the seeler never answered my questions about the type, psi, etc..

Thanks for the info. That is probably where I will get mine from :thumb:
 
#7 ·
horizontal with weep hole down.:thumb:
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top