Ford Powerstroke Diesel Forum banner

Truck Acting Crazy

1K views 5 replies 3 participants last post by  ianstew 
#1 ·
I was slowing down to turn into the gas station and once I turned in and started to give it throttle it wouldnt do anything. I held it to the floor and it just idled. So I changed settings on the chip and it started missing and finally died. Cranked and cranked and finally started back. It run like crap so I turned it back on the 140 setting and it sounds like it has single shots or something or huge cam. any help is aprieciated. codes are

P1280
P0198
P0113
P1690
P0475
P0340
P1210
P0541
 
#2 ·
i cant help you with the codes, but it soundes like an 02 sensor located just below the injector bar and valve cover on the drivers side. easy to replace. you should go to a diesel shop, not ford and for about 35 dollars they will diagnose for you . and you can go home and fix it. if it is o2 sensor. replacement is under 100.00 dolllars. gl
 
#4 ·
I was slowing down to turn into the gas station and once I turned in and started to give it throttle it wouldnt do anything. I held it to the floor and it just idled. So I changed settings on the chip and it started missing and finally died. Cranked and cranked and finally started back. It run like crap so I turned it back on the 140 setting and it sounds like it has single shots or something or huge cam. any help is aprieciated. codes are

P1280 ICP Circuit Out Of Range, Low
P0198 EOT Circuit Out Of Range High
P0113 IAT Circuit Out Of Range High
P1690 Waste Gate Control Solenoid
P0475 EPR Circuit Fault
P0340 Inactive CMP Sensor Circuit
P1210 ICP Sensor Fault
P0541 Manifold Intake Air Heater

here ya go :thumb:
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top