KCR Chat Thread

**SMKSTAX** · #1 (**permalink**) 03-25-2009, 07:47 AM

Well it's official we are a chapter!! So here's our chat thread where we can gab it up and talk. Where's everyone at??

**harrys91rs** · #2 (**permalink**) 03-25-2009, 10:06 AM

Nice, i'm here! Just getting ready to fix my nerf bars. Bolts were rusted and broke

**SMKSTAX** · #3 (**permalink**) 03-25-2009, 10:11 AM

So you just replacing the bolts with new ones?

**harrys91rs** · #4 (**permalink**) 03-25-2009, 10:14 AM

Well, the bolts are broke and rusted into the bars. So i have to drill out the old bolts and weld in a nut, then put it on the truck with new bolts. I spent $10 on bolts, better than spending 400 for new bars

**SMKSTAX** · #5 (**permalink**) 03-25-2009, 10:18 AM

10 is always better than 400 that's for sure!!

skoalcowboy22 · #6 (**permalink**) 03-25-2009, 11:29 AM

Im up in NY but will be keeping an eye on this cause I used to live in PA and come down there for my decal business a lot

**03-blue-Powerstroke** · #7 (**permalink**) 03-25-2009, 01:48 PM

Anybody on?

Gruss · #8 (**permalink**) 03-25-2009, 01:52 PM

I'm here, just got my new boots for my intercooler.

I had to get some 3 1/4 to 3 " reducers to go from the intercooler to the Banks pipes. Hopefully be able to get it put on in a week or two,

**03-blue-Powerstroke** · #9 (**permalink**) 03-25-2009, 01:53 PM

Thats exactly what I need! I have to get a new boot to make my Banks intercooler pipe fit right.

**SMKSTAX** · #10 (**permalink**) 03-25-2009, 01:55 PM

Yep i'm here too, what's going on? Gary good luck with the install!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode