Any ideas?

firefightered22 · #1 (**permalink**) 01-11-2010, 04:28 PM

I have 6 inch smoke stacks on my truck and i have a tool box on it. i would like to put a tonneau cover on it. Im gonna cut the holes for the stacks but dont no what to put around the cover holes so it doesnt burn or melt. Any ideas?

03-blue-Powerstroke · #2 (**permalink**) 01-12-2010, 08:33 AM

You could do something like this...

Gruss · #3 (**permalink**) 01-12-2010, 05:23 PM

How about just running a smaller pipe inside the stack? Letting the stack just be like a heat shield?

firefightered22 · #4 (**permalink**) 01-13-2010, 10:58 AM

thanks. either of them may work. i already have a plate made and on the truck like the first one. i will just have to get my cover cut down

03-blue-Powerstroke · #5 (**permalink**) 01-14-2010, 10:21 AM

Yep it should't cost too much to have it cut down.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement