Do-It-Yourself replacement of parking and marker lights.
I had to replace the front parking and marker light today in preparation for my annual inspection. I removed the two screws that I could see, but the unit wouldn't come free. So, I purchased a Haynes manual and that was less than helpful as it didn't answer the question that I had.... what else did I need to do, other than the two screws, to remove the unit. Well, I figured it out, and am sharing it here. I replaced the headlights while I was at it (a little hard with the batteries in there), but didn't take any pictures.
Hopefully this helps someone.
Difficultly: 1 (easy as heck)
Marker Light: 194
Parking Light: 3157
(see complete list below)
Step 1 / Image 1
Remove the two Phillips screws (The red circles that I added to the image as the camera didn't pick up the screws). The 'unit' is the entire amber portion around the headlight. It is all one part.
Step 2 / Image 2
Pull the whole unit out. Yes, there are two studs holding it in, but you just need to pull. I found it easier to pull out the bottom inside first and then the upper stud. This image shows the top stud after I pulled out the unit.
Step 3 / Image 3
After the unit is out it gets really easy.....
For the parking or sidemarker lights, just turn the section, pull it out, pull the bulb out, put in a new bulb.... no kidding, huh?
Anyway, the hard part for me what not knowing that I could pull the unit out without breaking it. I don't want to pull on parts to see
if they will come a part just to break something.
Put it all back together the same way.
With my expert skills in Photoshop (it is sad that I can do just about anything in Photoshop, but I haven't a clue how to draw a simple circle) you will see the following in the below image:
Red - the two studs
Green - Parking Light/Directional
Blue - Side Marker
Lights for your 2001 F250-550
High & low beam headlamp
9007 (replaceable halogen capsules)
Front turn signal
Rear turn signal
High mount stop light
Back up light
Under hood light