Ford Powerstroke Diesel Forum banner

Tool help, any way to mount a 1/4" shaft to a bench grinder?

538 views 1 reply 2 participants last post by  66Bronco 
#1 ·
I'm not sure what (if any) category this fits into but as so many of you are good with tools I wanted to ask for a bit of help.

I have a 2" scotchbrite wheel that's on a 1/4" shaft and I'd like to use it on my bench grinder instead of a hand held tool. I've checked out drill chucks, but my spindle threads appear to be M12 and I haven't found a chuck with that yet.

I have 6" scotchbrite wheels for the grinder, but they're larger than the 90 some odd holes I want to clean up.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top