What did you do with the DPF wires??

bikeme · #1 (**permalink**) 03-24-2011, 06:40 AM

As the title states, when removing the DPF what did you do with the wires that were connected to the DPF? Just tie them up out of the way or try and seal them up?

STROKMII · #2 (**permalink**) 03-24-2011, 07:30 AM

Yes to both!!!... I just tucked them up and wrapped them in electrical tape, in 2012 I have to make it pass smog so I will need to put the DPF/DOC back on...cuz AZ sucks for Deisels...

DSL_PWR · #3 (**permalink**) 03-24-2011, 10:00 AM

Coil the wires, wrap them in plastic and tape them up.

**tkobes43** · #4 (**permalink**) 03-24-2011, 10:11 AM

I just put them back into the pipe? The dpf delete pipe had holes for the wires to go back in?

DSL_PWR · #5 (**permalink**) 03-24-2011, 10:38 AM

Quote:

Originally Posted by tkobes43

I just put them back into the pipe? The dpf delete pipe had holes for the wires to go back in?

Some are running H&S and you do not need the sensors at all so you are left with wires.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement