Ford Powerstroke Diesel Forum banner

I'll break anything...

777 views 5 replies 3 participants last post by  TulsaDave 
#1 ·
So I put in a BPD FICM today. When I was putting the 4 pin screws back it the torx bit snapped off flush with the top of the screw. I ended up just leaving it there. I may have to deal with it one day in the future though. Any ideas how to get it out? I didn't want to risk damaging anything else.


Sent from AutoGuide.com App
 
#4 ·
Better get it out now before it comes loose and fries the ficm.

I would even go as far as to remove the screw with pliers and replace it.

And those screws just need to be SNUG not that tight!

I'm surprised you didn't crack the cuircut board.
 
#6 ·
Glue worked... Popped right out. Your right, that would have vibrated out.

Sure is easier to take that thing out the 2nd time.


Sent from AutoGuide.com App
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top