Those with Airdog 2, I need some help!

BlkSC · #1 (**permalink**) 09-05-2012, 10:12 AM

Can someone look at their pump and verify the red lead coming out of the pump is the positive and the green is the negative? I decided to make a new wire harness running 10 AWG wire to the pump and when I took the harness side connector apart I found the black wire hadn't even been stripped before the terminal was put on and it had just barely poked through the insulation. Anyway, lost track of which was the positive and negative. Thanks!

jimmyv13 · #2 (**permalink**) 09-05-2012, 10:45 AM

Does this help?

http://www.pureflowairdog.com/manuals/A5SABF193.pdf

The instructions are quite confusing.....the writing says the black is the ground, but the pictures show a green wire.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement