Whats everyone using for factory exhaust tips?

***MPTonyT*** · #1 (**permalink**) 02-15-2011, 10:18 AM

So I searched but didn't see what others were using. So after straight piping my factory exhaust i was entertaining the thought of adding a chrome or polished exhaust tip 5 to 6 inches or so. Something with a mitered finish maybe rolled edge. Something similar to the MBRP tip. Anyone know where i can get one that will fit the factory 3.5"?

Pics would be good if anyone has em.

bfrank81 · #2 (**permalink**) 02-15-2011, 10:43 AM

I like my MBRP tip. I think you can buy just the tip from them.

***MPTonyT*** · #3 (**permalink**) 02-15-2011, 10:50 AM

Quote:

Originally Posted by bfrank81

I like my MBRP tip. I think you can buy just the tip from them.

Everything i see on their site says for 4" i would hate to buy it and it not fit..

bfrank81 · #4 (**permalink**) 02-15-2011, 10:55 AM

There site is a PITA to use. Call/Email Adam at FCDP he can get you hooked up with whatever you need.

***MPTonyT*** · #5 (**permalink**) 02-15-2011, 12:18 PM

Tried calling twice. Got VW both times. Didn't leave a message this time but ill try calling later and if i get VM again ill leave a message.

**Dave** · #6 (**permalink**) 02-15-2011, 12:20 PM

Most of em make a 3.5 inch tip. I had a silverline on my old 7.3

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement