Insight with EAS

[2nazt]

Hey everyone I just figured I haven't seen any info on the EAS in a while so I emailed EDGE the other day and this is the response I got back from asking about a fuel pressure add on.

Andy,

We are planning on releasing these products towards the end of this year
and should have them out before Christmas.

Sincerely,


Mark Hayward
Inside Sales
1080 SOUTH DEPOT DR.
OGDEN, UT 84404
888-360-3343 x 138
801-337-2198 Fax
Edge Products| The Leaders in Performance Electronics

Just though I would share this with you all for those who were wondering.

[armyguy209]

Ohhh thanks for the info...I will be ordering this when I get the money for the EGT hookup.

[MUDSTROKIN']

Now if only i can convince someone to buy me an insight for christmas

[Dave]

Hmm I see a fuel pressure gauge in my future

[armyguy209]

Haha I still have to hook my CTS up..its sitting in the box in my closet. I took it right back out of my truck after I tested it because I was afraid it would get stolen like they do with the portable gps that people leave in their vehicles.

I guess ill just get the dash pod. I was trying to find someone to cut into my dash and make some kind of electronic actuator that would pop it out of the dash with the flick of a switch, and then hide itself back inside the dash when you hit the switch again. I took the dash apart and the heater tubbing to the far left driver side vent blocks most of the room. Still tryin to figure something out but I am pretty close. I have found a pretty small linear actuator that will do the trick and have started making a model out of a card board box. It won't be cheap as the actuator is about 100 bucks by itself but it would be really cool and unique. I am just trying to design some type of bracket to hold it in place now. The project is on hold due to no funds from job loss but maybe sometime in the future I will pick it back up whenever I get another job.