Banjo Bolts

cpanderson · #1 (**permalink**) 02-10-2010, 11:58 AM

Does anyone know the part number for the banjo bolts that connect your fuel lines to your heads, also looking for a part number for the extension cord for the block heater?

w_huisman · #2 (**permalink**) 02-10-2010, 12:34 PM

Don't know if this helps you at all, but there are quite a few of them on eBay.

smokin73 · #3 (**permalink**) 02-10-2010, 01:16 PM

Not sure on the bolts but the extension cord is nothing more than your everyday 12ga. cord

fordmasterdieseltech · #4 (**permalink**) 02-10-2010, 05:52 PM

do you need the bolt or the copper sealing washers that go with it?

B3YOND · #5 (**permalink**) 02-11-2010, 05:21 AM

The banjo bolts are M12 x 1.5 if that helps at all.

Calkidd · #6 (**permalink**) 02-11-2010, 05:38 AM

I am thinking while your down there you might as well run some larger lines.

**07stroker** · #7 (**permalink**) 02-11-2010, 06:18 AM

The stage 1 fuel kit from trusted would be a good upgrade.

***Ozone-etr1*** · #8 (**permalink**) 02-11-2010, 09:48 AM

Quote:

Originally Posted by cpanderson

Does anyone know the part number for the banjo bolts that connect your fuel lines to your heads, ?

yep here ya go:
W301866 (KIT,BANJO BLT)

***Ozone-etr1*** · #9 (**permalink**) 02-11-2010, 09:51 AM

Quote:

Originally Posted by B3YOND

The banjo bolts are M12 x 1.5 if that helps at all.

did you measure that or whwew did u find it?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement