Ford Powerstroke Diesel Forum banner

Rough Idle 7.3

860 views 3 replies 2 participants last post by  460+ 
#1 ·
HI Guys
I have a 99 f-250 that has a rough idle. I was looking at previous threads and noticed that there are a lot of problems with the ICP. I have an edge EZ module plugged into it right now so I went out and unplugged it to eliminate the chip. Truck runs like a champ now but I noticed that in the connection on the ICP there was oil. Is this a bad ICP allowing oil into the connection? Would this cause a rough idle? Or do the edge modules suck?
Thanks for the input in advance
 
#2 ·
:ORG welcome:Some programs control the ICP and at idle they run a little
rough. Hope this helps:thumb:
 
#3 ·
I have had problems with a previous module. I sent it back and they warrantied it. I think this one is wigging out too and it is still under warranty. I might end up going with bullydog. But does the oil in the ICP mean I need to replace that as well?
 
#4 ·
If you can blow it out and see if it fills back up if it does then replace it.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top