just died wont start

johnson123 · #1 (**permalink**) 10-03-2009, 10:12 PM

i have 7.3 last week it just died and wont start i have no wait to start light and programer wont come on all fuses are good and replaced cps

OregonStroker · #2 (**permalink**) 10-03-2009, 10:19 PM

sounds like it could be the pcm

johnson123 · #3 (**permalink**) 10-03-2009, 10:20 PM

anyway to check that

OregonStroker · #4 (**permalink**) 10-03-2009, 10:22 PM

what electronics do work in the truck? To be honest I really couldnt tell you how to check one.

johnson123 · #5 (**permalink**) 10-03-2009, 10:24 PM

everything seem to work right just dont have my wts or the programer and dose that mean id lose my chips

johnson123 · #6 (**permalink**) 10-03-2009, 10:25 PM

and when i plug my chip in under the dash it says im not connected

OregonStroker · #7 (**permalink**) 10-03-2009, 10:27 PM

thats what makes me think it could be the pcm. Due to the fact that the code reader wont connect. do the dash lights come on when you turn thekey on?

johnson123 · #8 (**permalink**) 10-03-2009, 10:33 PM

ya all lights but wait to start u think if i put a scan tool on it and clear all codes it would work cuz i have 2 new batteries in it and the glow plug synod post broke off so put new one on and new cps in too

OregonStroker · #9 (**permalink**) 10-03-2009, 10:38 PM

does the scan tool start up when you plug it in and turn the key on?

johnson123 · #10 (**permalink**) 10-03-2009, 10:39 PM

dont have it yet have to wait for school monday but my chip on dose not work didnt no if there would be any diff in the 2

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement