Rookie mistake, tore the wires off of the Cold Air Intake sensor

[FLYING BONES]

I'm new to this truck, and when pulling the AFE intake to change out my water pump I ruined the sensor that plugs in to the intake. (Didn't realize it was there) The problem is that I pulled the wires out of the female plug in, so I just have two wires hanging with no female end left for the sensor to plug in to. I don't see a way to put it back together.

Does anyone have a solution for this?

BTW...thanks for all you folks do. I have been able to rebuild much of my steering (ball joints/tie rods/steering gear/power steering pump) and replace the water pump/fuel pump with the help of this forum.