replaced ball joints u joints need help PLEASE

[whateverittakes]

I have a 2000 F-250 4x4 I replaced the ball joints and the u joints in the front axles. I put the hub back on then now I'm ready to put the thrust washers back on the axle. Their is 2 round washers and 1 washer that is shaped like a stop sign and one clip that locks into the axle . My ? is How does it go back on the axle? Is it washer, stop sign washer, washer, clip on axle then the 4x4 locking hub slides in? or is it washer, stop sign washer, clip on axle, washer then the 4x4 locking hub slides in? I have searched the forum and even looked on utube.com and not a forsure anwsers yet. Any Help would be greatly appreciated Thanks

[gary2070]

According to Chilton....."be sure to place the non-metallic washer between the two metallic washers."

[whateverittakes]

So it will go washer, stop sign washer, washer, clip then the 4x4 hub. Is that right?

[gary2070]

That's my thinking....

[whateverittakes]

Thanks Gary2070. Is there anyone that knows for sure?