|
|
|
|
- HOME
- FORUMS
- GARAGE
- ARTICLES
- CHAT
- CLASSIFIEDS
- VIDEOS
- TECH
- STORE
- SPONSORS - - REGISTER - CALENDAR - SITE HELP - ARCADE - STAFF - MEMBERSHIP - GET A QUOTE |
|
Welcome to the Ford Powerstroke Diesel Forum, the fastest growing Ford Diesel Community on the internet! You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact contact us |
|
|||||||
|
|
|
 |
|
|
LinkBack | Thread Tools | Display Modes |
03-20-2007, 06:25 PM
|
|||
|
|||
|
Bearings in dana floating axle
Can anyone please tell me if it is really necessary to pack the rear wheel bearings in grease before re installing even though they run in gear oil? I'm in the middle of putting new brake calipers, rotors, and pads on the rear end. Also is the o-ring axle seal enough, or do I need to use silicone? I prefer to NOT use it.
I want to try to finish this tomorrow so any info would be AWESOME! 
|
| Sponsored Links |
|
|
|
03-20-2007, 06:34 PM
|
|||
|
|||
|
a little grease is a good idea....but dont "pack" them.... Just reuse the old o ring on the axle...its not all that common to have them leak
|
|
03-20-2007, 07:45 PM
|
|||
|
|||
|
Thanks for the info! I was confused about the grease/oil combo.
|
| Sponsored Links |
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
