Ford Powerstroke Diesel Forum banner

chaffed wires while replacing ICP

713 views 0 replies 1 participant last post by  stuart01 
#1 ·
So I replaced my ICP sensor and while I was doing it the other sensor right beside it I noticed a bare wire, so I pulled the wire out of the harness and it was melted and twisted together for about 6 inches. I hope that when I crank it up it runs better, Between the bad ICP sensor and the twisted bare wires it has to.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top