- need help
- added archoil oil, now have oil leak
- Need help! Was given wrong oasis...
- brakes and rotors
- Weird whistle
- Question on HPOP
- SCT X3 Locked, Only option to send it to SCT? Or somewhere else?
- Another temp delta thread.......
- Two Questions.....
- Cheapest turbo timer
- wheel adapters?
- Dual coolant filter install
- Bored buying - blue sring and fuel additive
- hello from ohio
- Coolant Flush?
- IPR high folow coolant filter install question
- oil change
- cooler temps
- Battery Voltage
- Irritating issue.
- stc fitting installation??
- Need to surface heads .008... safe?
- Overboost know this has been asked, HELP
- Under the Knife and need advice
- Tire size! Help please
- Should I buy?
- cruise question
- Proud Owner of a 05 6.0 Ex
- 05 F350 Wheel Question...
- Broken Brake Line
- Oil additives?
- Daystar leveling kit
- Buying a truck - Transmission fluid flush time?
- HPOP system questions
- Towing and Fuel Mileage?
- Aux fuel tank, which filter?
- Ball Joints Shot?
- Restore/Restore Plus
- Question, Not Actual Mileage
- Fuel tank pick up tube
- Exhaust Manifold leaking (pics).
- coolant presssure question???
- Fuse removal while working on truck's interior
- Worse than the night before xmas
- DO I have a FICM Tune?
- How do I change and or service my steering bushings?
- Supercab roll down rear windows
- Changing exhaust tips for different tone?
- Need some tools !!
- EGR blockoff rage
- What maintenance to do ??
- Anyone Run a Volant SS Exhaust
- Idle sound ?
- Secondary Fuel Filter Housing Fuel Prime Question
- Sound question
- Oil cooler vs studs
- NEED HELP ASAP
- Low voltage FICM...during am startup
- just ordered my new bumper
- Whats it cost to have the injectors reworked?
- Autoenginuity
- fuel guage stuck on full
- Head gasket checklist
- Salvage vehicles
- after market check valve...
- Rotella T6
- IPR updated stand pipe kits, NEW PRODUCT!
- horrible MPGs, even worse after flash!
- Installation Help (frame insulators)
- Where oh where can I find door molding
- Turbo boost
- Ficm stats.
- Edge Evolution tire adjustments with SCT being used
- Atlanta Motor Speedway
- 6.0 or 6.7?!
- Bulletproof Diesel Oil Cooler INSTALL
- Need Clarification on the Edge CS/CTS
- raising kit for f350 2005 ,6.0 doesel
- EGR DELETE CODE LITE ON
- oil leak....?
- Axle rust solution?
- Bigger Injectors!!!
- Opinions on atlas 40 ficm tune by ficm repair.com
- CTS Readout!
- 10 Vane Turbos
- FICMRepair.com
- Choosing between a 7.3 and 6.0
- Truck only runs if i manually power ipr
- installed coolant filter
- Parts for my rebuild
- BlackStone ATF Analysis
- long term storage
- 3.5" or 4" Turbo Downpipe??
- Does a standard CEL reader read a diesel?
- Got some MOD questions and need help asap lol
- Question on RPM while towing.
- WTF.. Just bought 06 PSD F250 Ticking noise
- 6.0l running rough until full warm and barely starts unless plugged in? any help
- ARP studs in, do i have to re-torque
- egr question
- Block heaters in all 6L?
- how much brakes left?
- turbo inlet leaking-
- Will an Edge Insight CS Clear code for egr delete? on 2005
- Need help with codes
- Arp stud process question
- 6.0 Running Rough
- Tuners and programmers
- Key pad on drivers door 2004
- Cleaning turbo and intake procedure?
- Pillar pods wanted
- 6.0 or 6.4 Engine test stand
- Who sells front swaybar bushing kit, 2005+????????????????
- what else do i need
- dealers 3 month 3000 mile 100 % parts and labor
- This 6.0l sounds badass
- Best YouTube Truck Videos!!
- How many miles do you have on original injectors?
- My first $100 truck lesson.
- Tips for driving a manual 6.0? (ZF6)
- OBDII codes
- ABS plug
- Turbo
- engine fan
- Upper consol
- A second 6.0
- Back to stock tune or milder tune?!?
- Cold Start Up and Warm up Time
- SCT egt probe with dashboss?
- Do you trust your 6.0?
- Engine build date...FICM sticker question...
- New Here
- head gasket install help
- constant door chime
- New noise developed
- Tunes
- Commute/Temp discussion
- Scangauge with Blendmount
- Gear Oil???
- disconnected plug at water/fuel separator
- Need some solid advice
- FICM Relay
- Fuel pressure gauge
- what brand thermostat?
- check engine lite
- Stock down pipe with 4" cat-back system?
- *Leaking Coolant Help*
- Head Gaskets??
- Superchips iHAWK
- doing heads what about my injectors?
- Edge CTS Accurate FICM voltage
- 2006 PSD temp issue??
- Newbie Here. Please be gentle.
- driveshaft u joints
- Snow Plows
- EGR delete - 06' F250
- Block heater cord
- Need 6.0 Help for newbie
- Is it a good deal?
- up pipe
- Heated jumpseat
- Icp pressure significantly lower w tune
- No brakes
- FICM???
- Pressure sensor at HCFM
- Multiple 5th wheel trailers?
- coolant filter kit
- Putting F250 blocks on an F350
- cooling fan ?
- 99-06 to 08+ Mirror Conversion using uplifter switches??
- Uneven Cranking?
- Bpd oil cooler?
- Turbo ????s
- Bucking at high speed 2005 6.0
- blue smoke problem
- I need HELP please read is all I need.
- Puking at higher elevations
- Refinishing Aluminum Wheels?
- anyone else's truck smell like fireworks?
- Major upgrades need advice
- ideas for anti-theft
- Tools needed to drop fuel tank question
- Tune/Replace EGR
- Finished the head stud install with new injectors and blew out injector snap ring!
- 6.0 in to an older car?
- any truth to this?
- Upfitter switch heated mirror mod
- 2004 F250 6.0
- Check this out!
- oaisis report
- How long to warm up?
- im changing my 6.4 banjo bolts back to stock bolts
- Identify this plug
- somthing different every day!
- air bag sensors?
- 03 6.0 EGR DELETE question
- WARNING: FRAM filter CH9549 changed
- 6.0 to blow black?
- Lowcountry of SC... Stolen F250
- buying a 6.0 in near future
- 2007 F250 PSD CREW - Just picked it up!
- Typical beginner Q's
- 6.0 pulling a 6.7 cummins
- used vehicle inspection
- New to Ford and well it's been rough
- Mobil delvac elc?
- 6.0 powerstroke owners input
- Right Locking hub wont turn :(
- MADTURBOWERKS - Adrian's Transmission Build Thread
- New, and looking at trucks!
- anyone near mn want to convert to drw2?
- help diagnose vibration.
- Boost psi?
- Coolant filter question
- Coolant flush question
- the right fluids for the right job.
- egr delete
- elk vs truck
- What do you need for a stock 6.0 to smoke???
- getting a to do/parts list together for stud job
- Need advice on purchase 189k mi 6.0 W/5th wheel?
- The me too rebuild thread... HG/ARP etc...
- coolent filter
- High coolant temps
- 4in turbo back. muff or no muff
- Delo 400 5W-40 full synthetic
- Gooseneck trailer towing setups
- Truck stolen !!!!!!!!!!!!!!!!!!!!!!!!!!!!
- Installed new thermostat temps still low
- Long crank..low voltage on insight..batteries good..?
- Aiming headlights?
- Truck shakes or vibrates when slowing down...?
- Maint. Schedule
- bumper recomendation
- Questions? Oil filter housing is dry. With pics.
- ficm repair & bad injector.
- 6 speed Turbo Back
- fuel pressure check
- New member-Tuner/guage question
- 6.4 banjo bolts
- 2005 F350 Dually tire upgrade
- New FICM - still starting problems
- Info on IPR coolant install with manifold
- SCT Tune Advise (IDP)
- Turbo swap question
- Rev X
- Questions about buying a 2007 6.0
- Fuel Guage Issue: Sender Replaced
- What kinda time frame for changing stc fitting
- Rough idle after coasting