6.0 Motor problems [Archive] - Page 51 - Ford Powerstroke Diesel Forum

: 6.0 Motor problems


Pages : 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 [51] 52 53 54 55 56 57

  1. looking for a general consensus
  2. Fuel Problem???
  3. Question for the 6.0 Fellas
  4. Signs of Bad head gaskets
  5. Puking coolant issue
  6. internal back fire?
  7. New oil & EGR cooler 1 day later something else
  8. how to get rid of built up soot
  9. EGR water flow?
  10. glow plugs
  11. Joining the Headstud Club!!
  12. 6.0 With sticking Turbo??
  13. long crank, white smoke, runs good!!
  14. PLEASE HELP COOLANT SPEW!!! PICS INCLUDED
  15. White smoke and coolant loss
  16. Check Engine Light but No Code?
  17. Attempting Head Gaskets Myself- any hints?
  18. exhaust vibration??
  19. Engine removal
  20. EGR codes
  21. 03 Low boost after numerous parts
  22. Likelyhood of Head problmes
  23. TECHS: Surging Under Light Acceleration When Cold.
  24. head gasket question
  25. Out of Warranty EGR Cooler and Oil Cooler Failure
  26. White smoke when cold!
  27. 2003 6.0 problems need help
  28. Loss of coolent
  29. Drivers Side Up Pipe Replacement help
  30. Possible egr or something else...
  31. turbo farts
  32. losing coolant and rough start when cold
  33. Turbo/VGT Valve Problems
  34. Headgaskets
  35. 6.0 Stump
  36. possible FICM
  37. Truck has no power at all
  38. Back to the dealer again
  39. Air Noise/Hiss
  40. whistling worse after EGR and TSB 081103
  41. Another Head Gasket Story - Long Read
  42. 06 6.0L Turbo Problems
  43. Rough start and black smoke?
  44. EGR problems????
  45. cold start issue
  46. Air Filter Sensor
  47. Coolant Problems
  48. injectors
  49. Turbo flutter
  50. help with water in gas
  51. 04 with weak start
  52. 2005 Oil cooler replacement
  53. NEED HELP black smoke and not the good way
  54. Is this puking?
  55. Glow plugs
  56. stumped
  57. seems high press oil problem
  58. Studded and puking
  59. FICM
  60. Now What dropped off @ dealer this morning
  61. Turbo Issues on stock 6.0L need help
  62. 6.0 Gets Hot Dies Will Not restart
  63. 2006 6.0 crank no start
  64. Blowing oil badly
  65. Will new head gasket prevent future problems?
  66. EGR COOLER or HEAD GASKET? 2004 6.0
  67. Ran out of fuel...
  68. 03 6.0 will not start
  69. will not start 2004
  70. science behind blown head gaskets
  71. long crank white smoke
  72. New FICM?
  73. Are my vanes sticking?
  74. Help needed in Iraq
  75. 2006 6.0L dealer says high pressure oil leak
  76. ICP Sensor Help
  77. Turbo Question For Mechanic
  78. Poor Acceleration please read!
  79. Truck Died
  80. Chugging at Idle when in Drive
  81. fuel line..$212.00 holy cow
  82. 6 OH!! could this be y it runs like chit!
  83. BD Boost Fooler
  84. 2003 6.0L No Power Accelerating
  85. Diesels Suck!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
  86. UNBURNED FUEL IDLES FINE???????
  87. runs no throttle
  88. boost a perf ?
  89. I think my trucks is going threw another turbo(4)
  90. 03 problems???
  91. 03 6.0 stalling, missing intermittently need help
  92. 05' hard start
  93. Oil cooler
  94. Turbo crapped out.
  95. 06 f350 running rough blueish smoke
  96. Heater problems
  97. Cleaning Turbo
  98. Question on Headstud install
  99. hey guys need a hand
  100. Intermittent miss
  101. STUDS INSTALLED AROUND HOUSTON?
  102. Turbo Question
  103. low power stroke
  104. odd squeal/whine when let out of wot
  105. Turbo Cleaner
  106. 6.0 cuts out at speed and blows white smoke
  107. need help on asap
  108. Still blowing smoke... Bad Turbo??
  109. Cooling Fan problem ??????
  110. Fuel leak
  111. $2000 OIL COOLER?
  112. Turbo Connections
  113. ICP sensor problem?
  114. what programmer that can turn off EGR valve
  115. EGR and OIl coolers HELP
  116. Whistling noise in cab...
  117. HPOP Leak?
  118. Tech Help
  119. egr cooler
  120. picked up truck from dealer last night.
  121. Tell me if I am on the right track (EGR Cooler)
  122. Turbo Surges under load occasionaly
  123. 6.0 suggestions please
  124. Possible problem?? DTC 9352??
  125. Dang! threw a code. Help??
  126. 1995 E-350
  127. 2004 f-350 error code p2614
  128. P0148 P0603
  129. 05 Hiccup under load
  130. 05 Hiccup under load
  131. White Smoke & Runs Really Rough / Need Advice
  132. CONTRIBUTION CODES CYL 2,4,6&8
  133. "Dragging" feeling in the mornings?
  134. CALIF LEMON LAW BUY BACK
  135. 6.0 no power on take off.
  136. Up Pipe
  137. turbo rubbing???? 6.0 2003
  138. Puking Problems
  139. Turbo laging for long time??
  140. only 20 pounds boost
  141. EGR replaced
  142. trouble codes,please help
  143. New Batteries or Block Heater Cord?
  144. egr delete question
  145. Leaking or burning oil?
  146. Turbo not covered by ford
  147. Turbo noises?
  148. Can you delete the egr?
  149. Exhaust Leak question?
  150. Anti-freeze on the Driveway?
  151. Need Some Help
  152. thar she blows!!!!
  153. radiator warranty question...
  154. Fuel Pump
  155. Engine Quit
  156. '06 6.0 cranks and cranks but wont start!
  157. Low Boost
  158. Does the 6.0 100k warranty cover the fuel pump?
  159. another injector post...alternatives to OEM
  160. Turbo doesnt work right in the cold
  161. another egr question techs please help
  162. Blown Head Gaskets, dealer won't stud it
  163. no heat
  164. hard start, runs only 2 seconds
  165. oil leak
  166. pic of my gelled up filter....crazy
  167. EGR Delete
  168. help!!
  169. less boost after egr cooler block off and up pipe upgrade
  170. Light colored smoke out of exaust (EGR?)
  171. TBC
  172. 6.0 Check engine light coming on.
  173. Turbo Problem - No whistle - need help!
  174. camshaft overperformance fault
  175. P0404, P0405, P1000...running crappy cold
  176. whistling problem
  177. Oil leak issue
  178. extened crank/ slight rough idle
  179. Glow Plug test?
  180. 6.0 overhaul cost?
  181. Help 6.0 Running rough, No power at OBDII
  182. Good Dealership in DE/ eastern shore MD
  183. Rough start in the morning
  184. Limited heat from heater
  185. Blown Head Gasket
  186. Back From Dealer
  187. radiator help
  188. Blown Head Gasket(s)!
  189. degas bottle
  190. 06 F350 puking water
  191. Truck shutting down when stopped or coming to a stop??
  192. Is the dealer trying to gouge me?
  193. How do you know the vairable geomitry of the turbo is working?
  194. 03 Hpop failed, what to clean?
  195. 6.0 studded,egr delete still puking under heavy load!
  196. 03 turbo wastegate question
  197. Low fuel Light???
  198. Problems starting up
  199. engine/ turbo surging while towing..video too.
  200. Cooling problems at -30F
  201. truck hardly starts
  202. injectors & egr
  203. EGR, Should It Stay, Or Should It GO??
  204. help egr removal now no power
  205. 2004 f250 6.0 rebuilt...now won't start
  206. egr Question
  207. Rough running at cruising speed.
  208. where can i get headgasket for 6.0
  209. Blown Head gaskets?
  210. Problems with 04 6.0
  211. 6.0 no start after error on programmar
  212. 6.0 problem
  213. 2003 f250 no start
  214. bed plate leak
  215. CEL & Glow Plug Light... help
  216. Loss of coolant + whistle
  217. Turbo trouble???
  218. Knock.…Black Smoke….Dead II
  219. Gurgling???
  220. 6.0 cranking but not starting
  221. rolling idle
  222. WHistling
  223. Oil in the Intake??
  224. 04 6.0 won't crank...
  225. 6.0 reman issues
  226. Ford Scam on ARP Headstuds??
  227. Straing Start/Idle
  228. blue smoke on cold start and heater stopped working
  229. Code P2262
  230. need help and fast
  231. Need some tech assistance please
  232. Coolant LEAK
  233. 6L No Start!! Help!!
  234. No start condition
  235. Head gaskets pooch'd. Know how do i get rid of evidence
  236. Rough Idle
  237. What's this..??
  238. Help Turbo problems
  239. Help
  240. 6.0L Motor Oil???
  241. icp, egr, now what?
  242. I think head gaskets
  243. Cranks, no start.
  244. Big Problems
  245. 6.0 and going broke
  246. smoking problem!!
  247. Betting the HG's are blown again.
  248. Head gaskets????????
  249. 6.0 Problems
  250. won't start under 40deg F