6.0 Motor problems [Archive] - Page 10 - Ford Powerstroke Diesel Forum

: 6.0 Motor problems



  1. No Start - all 8 injector circuits high
  2. oil in the intercooler
  3. 0299 turbo underboost
  4. 6.0 engine work price
  5. Loss of power then black smoke when power returns
  6. rough idle and intermittent white smoke
  7. Vgt problems
  8. Buddy's '06 problems
  9. 6.0 Stalls without Throttle
  10. Low Voltage Issue
  11. Turbo Oil Supply leaking badly at STC fitting
  12. Thumping noise after head gasket and stud install
  13. FICM-Fuel Contamination
  14. 2006 6.0L new oil cooler and EGR cooler still getting high EOT/ECT deltas??
  15. How to check batteries (dual battery setup)
  16. Head Lift bracket
  17. maybe overheating maybe not
  18. Need Help with Code P012F Oil Cooler
  19. Blowing white smoke
  20. Need help identifying electrical part.
  21. Coolant question
  22. Fuel pressure/boost.....so lost :(
  23. Makes 350 PSI with the IPR unplugged
  24. P0232 Code
  25. No power but no symptoms
  26. Any input on blue smoke?
  27. Time for studs I think!!
  28. Ficm voltage question...67-68 volts?
  29. Cylinder Head Issue
  30. turbo question
  31. Coolant PSI Question.
  32. How do I test for a leaking injector.
  33. Stranded roadside need help ASAP!
  34. 6.0 Not Working Great!!
  35. difference between front covers
  36. Missing/hard starts
  37. coolant pressure with bad oil cooler
  38. engine from hell
  39. GPCM
  40. Possible HPOP problem
  41. few questions about degas bottle
  42. Need some ICP/HPOP advice.
  43. Turbo sounds different. Black smoke from exhaust
  44. HELP! Turbo?Y Pipe? Air Filter Howling and Squeal? CAN'T FIGURE OUT!!!
  45. High Pressure Oil Leak
  46. Water temp/oil temp ficm voltage
  47. 6.0 head studs cab on install questions.
  48. No boost randomly
  49. One more EOT thread...
  50. Testing the IPR valve smoked it!
  51. High oil/water temps
  52. Pcm
  53. 2007 egr delete revs f'd now
  54. 6.0 headgasket blown...what else should should i get done
  55. Looking for help on a tough problem
  56. Turbo and radiator issues...
  57. TEA KETTLE NOISE
  58. Valve sticking?`
  59. Front cover/engine oil pump install questions
  60. 2005 6.0 boot at the turbo
  61. No hot start... HELP
  62. Need HELP 2003 F-350
  63. fuel issue sound????
  64. no start problem found oil underneath
  65. Truck won't build boost to launch
  66. Need help ordering parts.
  67. V band clamp part
  68. turbo issue
  69. Lifter failure. Engine rebuild
  70. 6.0 starts but cranks long runs like crap!
  71. No start
  72. A/C Blows hot at stops, cold on the go?
  73. bunch of problems
  74. Turbo not cycling
  75. 03 6.0 knocking
  76. 6.0 no start
  77. 2004 f250 stalling
  78. Erratic RPMs when reved in Park
  79. HPOP Housing RTV
  80. Skipping, no power and no CE light
  81. studder issuse and fuel pressure problems
  82. Injectors caked in carbon up to end of nozzles
  83. new injectors, still smoking?
  84. Turbo?
  85. oil color
  86. Miss on Street Tune
  87. Confused about HPO air test...
  88. 05 ford 6.0 long cranks won't stay running
  89. No start. Cold. 3 batteries!
  90. Hot no start
  91. no start when warm
  92. turbo under boost and turbo over boost code at the same time
  93. '06 6.0 black and white smoke, shudder and miss on decel
  94. weird surge
  95. P0450
  96. 03 6.0 stand pipe/ dummy plug
  97. Late 04 intermittent no start, sync?
  98. 6.0 no start when hot
  99. 2007 DTC code P0205
  100. torque app question
  101. After egr and oil cooler replaced, now i have low boost code
  102. Updated oil cooler line 2003 options
  103. 2004 lower than normal towing power
  104. HELP! 2005 6.0 Motor
  105. Turbo Hose Blowing Off Solution
  106. Coolant in oil :dunno:
  107. 6.0 FICM failed attempt at resolder
  108. Blown Headgaskets AGAIN??
  109. Extreme Oil Temperatures
  110. BPD OIL COOLER install
  111. Question about block flushing
  112. 04 6.0 crank no start
  113. 03 6.0 long crank when WARM not hot.
  114. Engine Replacement Questions
  115. Piece of gasket dropped into HPOP area
  116. Intermittent turbo, codes.....again
  117. 2003 Ford F250 Powerstroke Oil leak after oil cooler replacment
  118. this subject is beat to death, no clear answer-yet
  119. 05 running like crap after new heads and studs
  120. Sct
  121. stalled out.....no start
  122. Please help. Black and white smoke. Need advice.
  123. ICP, IPR, injectors, or HPOP
  124. EOT/ECT Towing
  125. Recommendation for 6.0 mechanic in BayArea
  126. please help desperate for any advice
  127. Blue/white smoke at hot idle
  128. 05 Hot no start, updates done in FEB14
  129. 6.0 starts then quits
  130. Powermaxx turbo
  131. Maximum ECT/EOT Delta on Desert Crossing?
  132. Your PCM and tomorrow
  133. turbo bark , how much is normal?
  134. Hot Stall and No Start 05 6.0 Everything new. Completely Stumped!
  135. Coolant fluctuating/disappearing
  136. Cranks won't start
  137. Is this bad (turbo)
  138. 6.0 front crank install
  139. Engine Rebuild (am I being ripped off)
  140. Rebuilding a 240k '04 F350 6.0L used for heavy towing
  141. 6.0 after new Oil Cooler and EGR delete
  142. Intake gasket installation prep.
  143. coolant level goes up and down
  144. Odd oil temps right at start up?
  145. cold start up with a little white smoke
  146. High Deltas...My Turn
  147. FICM questions
  148. DIY EGR valve block off spool
  149. eot-ect ??
  150. need help asap over heating
  151. HPOP Air Test and New Standpipes
  152. headed for disaster??
  153. 03 f350 shut down on freeway
  154. 25 degree Delta, after second NEW oil cooler
  155. Turbo silencer
  156. Ford 6.0 coolant higher than oil
  157. Lost All Of My Coolant
  158. Oil leak at front of block
  159. white/gray smoke issue??
  160. misfire when warm not when cold
  161. white smoke startup
  162. Hard Start/No Start after Oil Cooler install
  163. Cooling fan is on all the time
  164. Overheating and P0480
  165. Problems after headstud install.
  166. 05 OIL Pressure ISSUE
  167. P0069, P0299, P0470 HELP!!!
  168. Getting frustrated, bent push rod?
  169. 2004 6.0 Check engine light after straight pipe?
  170. 6.0 fan clutch wiring. chopped!!!!!
  171. A/C lots of water
  172. The old days of computers
  173. EGR ????
  174. 06 6.0 No Start
  175. Died while driving.
  176. ICP Sensor Maybe Bad??
  177. Multiple leaks...please help me prioritize
  178. voltage problems please help
  179. check engine light and no codes
  180. please tell me it's not a head gasket
  181. Truck smokes white
  182. 03 6.0 cuts off then restarts.
  183. 6.0 turbo problems please help
  184. Need help
  185. Engine Data Sensor Error-2007 F350
  186. P006A Code
  187. Need a Nipple Cup Stat..Help..
  188. 2006 f250 power stroke "going code crazy"
  189. vacuum line left over after stud install
  190. 04 f 250 feels like its skipping
  191. How to clean intake and turbo
  192. 6.0 will turn over but not start
  193. no power full boost ????
  194. 6.0L is suffocating its self!
  195. Sluggish with smoke
  196. 03 throwing code P0132b
  197. no ac after new oil cooler and egr delete
  198. 6.0L Problem ruff running at high rpm only
  199. installed tunner and turbo will not produce boost
  200. 2006 6.0 Random Hot Start Problem
  201. Fuel rail plugs not put in by Machine shop
  202. Truck just turned off will not start
  203. External coolant leak, where is it coming from?
  204. Boost issues???
  205. Fuel line cracked
  206. White smoke when cold, please help!!!!
  207. help no power
  208. reman 6.0
  209. 2005 6.0 Won't start. Need Help
  210. ECT 182* EOT 208*
  211. HPOP is there a way to tell if one is bad out of the truck?
  212. Front crankshaft oil seal
  213. coolant in oil an blowin' externaly also
  214. Fuel in my oil ,,, any ideas?
  215. J Pipe leaking EGR delete
  216. Loses power, regains power with RPM, then dies. HPOP issue??
  217. High Pressure oil leak?
  218. broken pushrod
  219. No start, Stumpped!!!!
  220. Cooler Hose
  221. BLACK FILM/DEPOSIT ON FUEL PRESSURE REGULATOR CHECK VALVE
  222. 2003 6.0
  223. Hpop leak please help ASAP
  224. 6.0 nightmare
  225. TURBO PROBLEMS..... I THINK....
  226. tach jumps around and engine misses above idle
  227. At a loss
  228. Coolant loss
  229. Anyone know torque specks oil cooler
  230. 2004 6.0 loses oil pressure at idle
  231. Stall after head gasket replacement and updated parts
  232. Another Oil Leak Question
  233. Oil cooler backflush
  234. 2005 turbo problem
  235. Oh no!!
  236. 2005 F550 intermittent miss at idle and low rpm run
  237. new engine(everything), no power
  238. Diesel Newbie - Cold Start Problems
  239. 05 F250 6.0 motor problems plz help?
  240. 05 F250 6.0 motor problems plz help?
  241. Hard Starts When Cold
  242. no start
  243. Ebp codes, low power
  244. WOT smoke
  245. Another 6.0 no start, electrical?
  246. metal treatment ?
  247. Oil change and wider Delta split?
  248. Price for oil cooler and bullet proof EGR?
  249. Has anyone had FFD injectors fail?
  250. Replacing the oil cooler, Again.