Rear LiftGate Clear Coat (Plastic...) Issue

TurnerBurn · #1 (**permalink**) 06-29-2011, 07:06 AM

Well, it's too bad that the lift-gate has to have so much plastic on the exterior... Anyhow, most of mine is fine. However, there has been some bubbling and flaking taking place... Sucks. Especially since I've tried to protect it. So, have any of you had to deal with this, and or do you know how to repair this type of damage?

Thanks

Nem · #2 (**permalink**) 06-30-2011, 08:04 PM

notice mine has same prob

***CutterN55*** · #3 (**permalink**) 07-03-2011, 06:05 PM

Mine got really bad and two days ago actually I sanded it and epoxy painted the snot out of it. Looks good, should hold up okay.

TurnerBurn · #4 (**permalink**) 07-04-2011, 06:53 AM

Quote:

Originally Posted by CutterN55

Mine got really bad and two days ago actually I sanded it and epoxy painted the snot out of it. Looks good, should hold up okay.

Nice, thank you.

**nolimit** · #5 (**permalink**) 07-11-2011, 08:01 PM

Mine was really bad. I just removed it and had it painted for 40 bucs. Good luck.

Sent from my PG86100 using AutoGuide App

BigKid · #6 (**permalink**) 08-22-2011, 05:23 AM

Quote:

Originally Posted by nolimit

Mine was really bad. I just removed it and had it painted for 40 bucs. Good luck.

Sent from my PG86100 using AutoGuide App

How hard was it to remove? Mine is flaking, I'd like to pull it off and have it painted.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement