'00 Ex/ Prodigy Wiring

[Jon]

In the corner of that picture there is a gray connector. That is where the Ford supplied pig tail "in your glove box" goes. You wire your prodigy to the pig tail then plug the pig tail into that connector.

[4xtaco]

Sorry I haven't replied to this... I found the people I purchased the controller and pigtail from did not send me the right pigtail. I swapped it from someone local and it plugged right into the gray harness in the upper right of the picture.

BTW I used it this past weekend and it is a ton better than my old Tekonsha Voyager... this controller works very smooth. I mounted it in the cubby just to the right of the steering column.
I am putting my 520xl CB on the flat surface below the cubby. I mounted a 4' Firestick II to the drivers side mirror with a quick disconnect and clamp mount. I basically threw the CB in for this weekend and will clean up the install later.

[Tampa Real Estate]

That's where I put mine too. And mine connected right to that gray connector as well.

[Rescuediver]

Originally Posted by bamaboy473

I have one of those Tekonsha units, just never knew it went by the name Prodigy.

The Prodigy is or was the top of the line Tekonsha with a built in level and Incline/decline compensator...