Hi all new to the forum here, have read a lot of posts and found there is a lot of good knowledge on this forum so Im asking for some help as no one here in Australia seems to know much about these. I have a 2004 f350 drw 4x4 with 7.3psd and zf6 with around 363xxxkm engine was running beautifully until I fitted a ts 6position chip, followed instructions etc (had one fitted to 03 f250 7.3psd no problems) once fitted I started it back up and straight up had water in fuel light on, checked that drained fuel bowl etc light stayed on-all positions on chip functioning normally. Disconnected chip and now no wait to start light. I've checked all fuses/relays which seem all good have power going to the pcm but not wts or no tac while cranking. Any help much appreciated