Please Visit our Site Sponsors
|
Please Visit our Site Sponsors
|
 |
|
 |
 |
|
|
|
||||||||
 |
|
|
LinkBack | Thread Tools | Display Modes |
02-06-2012, 11:47 AM
|
|||
|
|||
|
no heat (bad switch?)
i just got a new vaccum pump so now my vent controls work again (defrost, floor, front, etc) but I still have no change when changing the switch from cold to hot. It's stuck on cold. Any ideas??? Heater core is hot, water pump is working good and circulating coolent good.
|
| Sponsored Links | ||
Advertisement | ||
|
||
|
02-09-2012, 05:30 PM
|
|||
|
|||
|
The blend door/motor not working would cause that. It's happened to me before. I think there is a write up here or 1 of the forums.
|
|
02-09-2012, 05:53 PM
|
|||
|
|||
|
It was the blend door actuator motor. Thanks much!
|
| Sponsored Links | |
Advertisement | |
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
