JW Valve Body

**deere4440** · #1 (**permalink**) 09-12-2008, 03:28 PM

Ok so i just got my VB in the mail today, and was wondering, is there anything special to installing it. Or is it just drain the pain, remove pan, remove filter, remove VB, and install new one. Then reverse steps. Or is there something else i need to do?

02stroke · #2 (**permalink**) 09-12-2008, 03:52 PM

i don't know but i got mine in today also, so it would be nice to know.

**deere4440** · #3 (**permalink**) 09-12-2008, 06:17 PM

Anybody....?

***strokin_early_99*** · #4 (**permalink**) 09-12-2008, 10:01 PM

Nothing special. You said it all in your first post.

Torque specs for the VB bolts : 120in lb.

CT Performance, Inc. · #5 (**permalink**) 09-13-2008, 06:49 AM

Important! You should tq in stages 3ea. starting at 30in lbs center bolts first then work out.

Cary

**deere4440** · #6 (**permalink**) 09-13-2008, 12:58 PM

Hey thanks guys, just got the VB installed. And it has a whole lot firmer shifts now!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement