I've got a 7.3 with a 68mm precision direct bolt on turbo with 160/100 FF injectors. I've been through a couple different sets of bellowed up pipes now because they all see to somehow twist, causing the bellow section to collapse partially. The up-pipes have been ceramic coated every time. Question is has anybody else had this problem? and does anybody have a solution to keeping them from collapsing?
I was under the truck recently and noticed my IH pipes are leaking a little through the driver side bellow. I was NOT impressed, but haven't had time to investigate further
PIS 175/80's, Van Turbo with EBPV, BD Billet Wheel
Lots of money spent at RiffRaff
Holley fuel pump, in tank mods, crappy riding leveling kit, DP-F6, 5 Gauges+Edge CS in dash, CB radio in Dash, over 100 goofy little mods
Still pretty slow, just less slow now.