Compression Ignition Addict
Join Date: Oct 2009
Location: Borger & College Station TX
Thanked 4 Times in 3 Posts
Mentioned: 0 Post(s)
Quoted: 3 Post(s)
Feedback Score: 1 reviews
Potential DIY intake problem
I did the DIY intake on our 7.3l about 4,000 miles ago.
I installed an e99 compressor wheel and CCV re-route the other day and the piece of exhaust pipe that I used as the joint for the
intake had a thin layer of VERY fine dust on the inside stuck to the inside.
I thought the whole reason of using this trash-can sized filter was because it filtered better than stock???
I know I installed it correctly (it's 2 hose clamps.... lol)
Is the dust in there fine enough to pass the filter and doesn't pose a problem
or is there an issue with the filter and should I worry about dusting the motor?
LSP Assistant Director
Got every PSD made...
My DD: '13 6.7L with Optimus Prime's wanker still on the exhaust