Gauges

OregonStroker · #1 (**permalink**) 06-12-2009, 09:49 AM

What gauge is the mass public of the ORG running? Ive got these glo-shifts.... Startin to think they are a bit off. I read a thread saying he tested some against a set of cobalts. Says the boost on the Glo-shift was 9psi lower? says the egts on the glos where 325 degrees cooler? Thats not very reassuring. What do you all think?

**CHUCK** · #2 (**permalink**) 06-12-2009, 10:09 AM

Love my AUTOMETER gauges!
Like anything else....you get what you pay for.

SuperStroker10 · #3 (**permalink**) 06-12-2009, 10:16 AM

THAT IS VERY COMMON WITH GLOW S HIT gauges. poor guage quailty, thats why they are so cheap to purchase??

***NCHornet*** · #4 (**permalink**) 06-12-2009, 11:21 AM

Glow Crap = get'em out of there!!!
All I use is Isspro, they make a lot of the gauges in the automotive industry. If you want the best pricing send me a PM, and no I am not selling them!!

NCH

jamstoyz · #5 (**permalink**) 06-12-2009, 11:24 AM

always used and trusted autometers. had a couple stewart warners and they seem to be good too. the isspros seem to be great also

**Dirk** · #6 (**permalink**) 06-12-2009, 11:27 AM

Optix gauges over here.

OregonStroker · #7 (**permalink**) 06-12-2009, 01:24 PM

thanks guys. I figure Im hitting closer to 30psi thats what has me concerned. I hope they arent way off. lol. trans typically stays around 140-150 when at operating temp. I can only pull like 24psi max. and my egts always stay below 1200 cause i never have my chip past 80. But if the egts are off in the 100s that is kinda scary.