White Smoke, Boggs down, acts like loss of fuel

[nitrooverride]

I have a 01 f250 7.3. Lately it has been acting wierd. It was idleing wierd...idle high then low then normal. I can drive it for about 30 seconds then boggs down and dies. Try to start it up again and the batteries die. I brough it home and checked the icp plug and there was diesel fuel all in the plug from where i didnt screw the new fuel filter and cap back in correctly and it sprayed fuel everywhere. So i took and air hose and blew out the socket and plug really really dry and plugged it back in and it idled great and drove great for about 1 minute. now if i rev it to around 2000 rpm it looks like firework smoke. It was everywhere. I dont know what it could be. Does anyone know what to do? My trouble codes are p0602, p0605, p1211, p1690.

[mschn99]

u need to replace the sensor....and clean the connector REALLY good... The sensor is leaking internally to the contacts, and is probably causing your issues by corrupting the ICP signal...

[nitrooverride]

how much do the icp sensors cost?

[nitrooverride]

also how do i remove the old icp sensor and put the new one in?

[bryanbrown]

they're abou $180. they screw in. You can unplug it, and the computer will default to a certain psi, and it will run fine, you'll just have the ses light on. I thought mine was leaking, but I just cleaned it really good, and it hasn't done that in nearly a year.

[nitrooverride]

how do you clean it? I am illiterate with this. I bought a new one. I think it is leaking out so i want to replace it just to make sure. I will let you know how it goes.

[nitrooverride]

ok i replaced the sensor and the code for that went away. now 3 more codes are showing up. they are P1140 Water in Fuel Condition, P0603 Internal Control Module KAM Error, P1316 Injector Circuit/IDM Codes Detected. What do i need to do?