I want to do the EBPV brake mod and realized the harness is tucked in there. Short of importing a six year old slave laborer from N. Korea to reach in there, how did you guys get at it? Take off the intake and go in from the drivers side? thanks
You really don't need to take anything off at all (I didn't). But what I did do was just unplug my factory harness instead of cutting it. I then made a post asking if anyone would sell me their factory pigtail connector and one of the guys on FTE went right outside, cut his off, and mailed it to me THAT DAY. I have this thing about hacking into factory wiring.... anyway, IMO it is a much better solution to leave the factory connector alone and make your own harness. Mine gets power from the factory 10amp auxilliary fuse (ign switched) in the panel behind the dash, runs to switch on the shift knob, then goes out to the brake along with a common ground for both the switch and the EBPV noid. I really should've taken pics. Took my like 3 - 4 hours, but i was being super anal and taking my time.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Ford Powerstroke Diesel Forum
5.4M posts
265.8K members
Since 2005
A forum community dedicated to Ford F-series owners and enthusiasts with a Power Stroke diesel engine. Come join the discussion about performance, bulletproofing, modifications, classifieds, troubleshooting, maintenance, and more!