Those who have done the diy injectors

[FORDBOY24]

i have a set of nozzles sitting here that I need to instal and from what i hear you need a special tool to swap out the nozzles..would any of u be willing to loan me or sell me the tool??....a even better question is do I really need a special tool? thanks guys

[01flatbed]

i just got done helping install 200 over nozzles on stage one's in school here. you really dont need any special tools. we needed a ftlb and inch lb torque wrench, scotchbrite pads and brake clean and some other assorted hand tools. did your nozzles come with a holder with 2 tabs to hold the nozzle cup? if not you need one of them. if you need any torque specs just let me know i csan get them for you. good luck!

[FORDBOY24]

thats all I have..obviously im getting new o-rings but whats the holder? whats it look like and where can I get them?

[choupique108]

the holder goes in a vice and the injector sits in the holder.

[Ryan Rønning]

I have a pic somewhere.

[01flatbed]

thats right. if you go on diy-injectors.com thge site is for rosewood injectors they should be able to help you out with a holder. the holder allows you to place the injector in a vise so you can properly torque it.

[FORDBOY24]

alright i wonder if the Holder is the special tool I was told I needed..never touched injectors so this should be a good learning experiance. anyone have a holder?

[FORDBOY24]

I was told by roosewood that they dont sell the tools or seperate from there kits unfortunatly...

[Ryan Rønning]

I am not having any luck finding it

[01flatbed]

wow thats pretty stupid lol i wisdh i could let you borrow ours...but its the schools tools and i cant lend them out sorry bud.