What is wrong???

20powerstroke00 · #1 (**permalink**) 03-01-2009, 07:32 PM

I pulled the codes with my Triple Dog downloader and I keep getting a code for exhaust pressure control valve high and also exhaust pressure sensor high, what could be causing this, it will do it within about 5 miles after clearing the codes.

Is there a problem or is this common for the programmer... and/or my lead foot from time to time

Any help (as always) is greatly appreciated.

20powerstroke00 · #2 (**permalink**) 03-02-2009, 08:01 PM

???????????

**dhanna6powerstroke** · #3 (**permalink**) 03-02-2009, 08:04 PM

Quote:

Originally Posted by 20powerstroke00

I pulled the codes with my Triple Dog downloader and I keep getting a code for exhaust pressure control valve high and also exhaust pressure sensor high, what could be causing this, it will do it within about 5 miles after clearing the codes.

Is there a problem or is this common for the programmer... and/or my lead foot from time to time

Any help (as always) is greatly appreciated.

Sounds like the exhaust back pressure sensor is bad or tube is clogged or a combination of both. Not a huge deal if that is it. You can clean the tube and just replace the sensor.

cchase · #4 (**permalink**) 03-02-2009, 08:08 PM

Quote:

Originally Posted by dhanna6powerstroke

Sounds like the exhaust back pressure sensor is bad or tube is clogged or a combination of both. Not a huge deal if that is it. You can clean the tube and just replace the sensor.

yep. the tube will actually rot out, so take a look at that.

20powerstroke00 · #5 (**permalink**) 03-04-2009, 07:58 AM

So where is the tube located, I tried to find it today but have no clue what I'm looking for. Thanks

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement