Ford Powerstroke Diesel Forum banner

Turbo center housing inspection

951 views 0 replies 1 participant last post by  a01f250 
#1 ·
I'm rebuilding the turbo off my 01 f-250 but I think maybe there might be a problem with the center housing. On the turbine (exhaust) side where the seal ring contacts the bore of the center housing there are several grooves that appear to be worn into it. I'm assuming they are not supposed to be there and the housing is junk, correct? Thanks!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top