rear end issues

smith.5316 · #1 (**permalink**) 06-16-2010, 02:18 PM

ok so i took the truck to the dealership the other day to get a pinnion seal replaced and have a few recals. I was a little discouraged to hear that me cam positioning sensor was not the one being recalled so i had to have it replaced anyways. Then they found that i needed a pinnion seal, both axle seals, rear rotors and pads. My question for you guys is do you think i could replace all this. i know i will have to pull out the axles but is it hard to replace the seals or get the rotors off?

smith.5316 · #2 (**permalink**) 06-17-2010, 01:26 PM

bump it to the top

powerstroketom · #3 (**permalink**) 07-08-2010, 02:00 AM

Mine need the same. I took the axle one one side today to have a look and it dose not look that hard a job to do. I just need to get some seals and bearings to do the job. Anyone got any tips.

Cumminskiller2007 · #4 (**permalink**) 08-17-2010, 07:46 PM

Im doing my seals and parkin brake pads this weekend i will let yall know how it goes

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement