Installing Transcommand, Removal of pins

[nastea]

Ok, before I end up breaking this transmission harness, does anyone have a clue on how to get the pins out? I have tried searching...maybe not hard enough, tried looking for a video...I just cannot seem to get the pins to come out.

The installation manual reads:

Reach in through the front of the connector with a small
screwdriver or sharp scribe; gently move the locking
tang away from pin No. 1 and remove the wire and pin socket
from the back side of the connector body. Repeat for pin socket
No. 11. Repeat for pin socket No. 12.

Maybe I have too much dirt in my eye, but I don't see a locking tang that holds the pins.

[szyd]

The pins have little tangs on the side. You must push them in while pulling on the wire of the pin you are tring to remove.

[szyd]

WAIT!!!!!!!!!!!! Why are you putting a transcommand on when Tonys tunes do the trans tuning for you? You better consult with Toney befor you realy mess somthing up.

[nastea]

Oh I wasn't aware the chip controlled tranny too. Guess I'll stop if thats the case

[CT Performance, Inc.]

Never ever use a trans command period!