Ford Powerstroke Diesel Forum banner

Gauge Install, please help!

967 views 6 replies 3 participants last post by  TDIPowerstroke 
#1 ·
Ok a friend of mine is going to sell me a couple autometer guages, a Normal boost gauge -30vac +30boost, and a standard autometer EGT guage. Where do i tap in for a boost/vac signal for the guage? On my race car, it was just to any boost/vac source, im not sure on a diesel

Also, where is a good spot to install the EGT probe? and do you guys think its wise to install it in the manifold while still on the struck?

Please let me know guys, want to install them this weekend.

Oh btw, its a 95 PSD.
 
#2 ·
Put the boost gauge in the MAP sensor line, and yes put the pyro probe in the manifold. Its fine to put it in while on the truck.
 
#3 ·
Ok, getting around to putting my gauges in my truck finally. I have everything figured out except the best spot to tap into for power? i dont care if the gauges dim or not, just need to find a good power wire when the key is on. where do you guys do it?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top