Edge evolution 1500

[Underdogpsd]

I got it for Christmas and then of course I programmed my truck to the "extreme" tune boasting 100 hp gains and 200 foot pounds of torque. I fired it up and took it for a drive, it ran great felt good sounded good I was building boost at lower rpm. Well I parked it over night and had no way to plug it in, so let the plugs warm up and hit the key...... Nothing. I let them warm again cranking for about 5 seconds she hit sounded like on two cylinders. It then died, white smoke is rolling out of my stack. I shut the key of and re warm the plugs as the light goes off it backfires. More white smoke. I hit the key and it fires it looked like a pulling truck cloud of smoke, just white. Now every start it fires up sounds fine then drops off I'd say 100 rpm. Then stays at that. What is she doing?

[351fifty]

Is she throwing any codes?

[Underdogpsd]

Originally Posted by 351fifty

Is she throwing any codes?

Nope not a single one. And I now the bulb works it light up when it's going trough start up procedures.


And she runs 20.28 in a 1/4 @ 68 and 0-60 14.28.

[blu1996powerstroke]

I had that same exact chip and it had really rough starts on extreme so i usually ran it on race it seemed to run better. But the same thing happened to me, hasent done it sense. i just upgraded and got a TS 6 position chip and it runs way better with that.