What a p.i.t.a....

BADAZZ97 · #1 (**permalink**) 03-17-2010, 05:38 PM

Well I finally got a dp for my truck and I tackled it last nite. after hearing nitemare stories about install, that was not the case here. install was a pc of cake. but i did spend 2.5 hrs REMOVING the flat p.o.s. piping. no jack and no saw. just a crow bar and a 3 lb mini sledge. i will guarantee that i will not do it again with out the right tools. but it was well worth it. all 3 hrs total lol

**Fordman247365** · #2 (**permalink**) 03-17-2010, 08:27 PM

yup, the pita of the job is the removal, glad to hear ya got it done, 3 hours aint bad at all

**ryandamo** · #3 (**permalink**) 03-17-2010, 08:55 PM

yea it really isnt to hard, most of the horror stories are due to lack of tools, the hardest part is cutting up that old one to get it out

TANPOWERSMOKER · #4 (**permalink**) 03-19-2010, 10:38 AM

what did u end up buying for a DP, bc thats one of my next up grades. I was looking into a mbrp 2 peace. dose any one make a DP over 3"???

BudDog · #5 (**permalink**) 03-20-2010, 07:01 AM

LOL I was putting my new clutch in when I put on the DP and it was a piece of cake!

**Fordman247365** · #6 (**permalink**) 03-20-2010, 07:21 AM

Cheater

BudDog · #7 (**permalink**) 03-20-2010, 08:06 AM

well what can I say?

**Fordman247365** · #8 (**permalink**) 03-20-2010, 10:20 AM

HOOOORAY hahahahahahaha

BudDog · #9 (**permalink**) 03-23-2010, 03:13 AM

I do like Cake!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement