Installing guages

**PSD97** · #1 (**permalink**) 02-26-2008, 04:30 PM

I finally broke down and bought a set of pillar mount guages for my '97 PSD; they are Glowshift guages, the typical trio (egt, boost, trans). Anyone out there familliar with this brand and/or any tips for installing? I plan to begin "adjusting" the performance of my truck soon and thought a set of these guages would be a good place to start.

Thanks in advance.

***vitalidle*** · #2 (**permalink**) 02-26-2008, 04:37 PM

Im not familiar with them, but I have seen a few people on here with them. Did they come with instructions?

**PSD97** · #3 (**permalink**) 02-26-2008, 04:53 PM

Instructions yes, pretty generic though. What I am really interested in is if there is a port on the transmission for the temp sender? Any tips (to make it easier) for installing the Pyro sensor for exhaust?

Triflex · #4 (**permalink**) 02-27-2008, 04:41 PM

Yep, there is, I saw it just the other day so I know its here. I remember it said there was a hole for it on the tranny that had a bolt in it. There was pics. also so you may want to search for it.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement