OBS chat

[copesetic]

Originally Posted by BigFuel

After a misting of water the last couple days my trailer is now stuck in a coue inches of silty mud

😒

Do you need help getting it out?

[BigFuel]

Thank you Craig. I got it, thank you gebiz for Posi's and for a diesel's torque at low speeds. I'll post pics of the chaos later. Gotta get this show on the road.

[lil o rinny]

Originally Posted by alberta 7.3

Did some ****ing around with the 16x2 line LCD. Modded and soldered on the serial board so it will talk to the Arduino with just 2 wires. Spent a couple hours troubleshooting the serial card, since there wasn't any documentation with it, one of the hazards of cheap Asian electronics.

Got some stuff half-assed on the screen so now I know the viewing area. The real test will be if I can stuff this thing into the speedometer or not. Once I make it fit, then I'll worry about things like block letters for the shift indicator.

Pretty badass Bill, I like it!

[blacksmoke powerstroke]

Bill how much for one?

[slepe67]

Replacing wheel bearings on my 95 F250 4x4 Dana 50. Is this the right spindle nut socket? Ive been fighting it for 4 hours wont budge. What am i missing?
Something isnt right. I even put an impact gun to it. Nothing. Thanks in advance


Sent from my iPhone using AG Free

[marine5811]

There is a little locking ring keeping those spindle nuts in place. Have you pulled that yet? (Can't tell by the pic.)

[slepe67]

The "half ring" behind it? It looks like its behind the nut. Do it just "pop" it out?


Sent from my iPhone using AG Free

[slepe67]

I took off that c clip. The spindle nut looks threaded on the OUTSIDE. The bearing behind it spins freely. LIGHTNING BOLT! Nevermind. I figured it out! I knew it was too damn easy!


Sent from my iPhone using AG Free

[marine5811]

Good! Yeah that's the one I was talking about.

[08spartan250]

hey fellas, check it out!

FREE MOTOR AND TRANS!!!

y'all helped me out a lot in the past, so I hope one of you can take advantage of this.