Spun the rollers yesterday

**alberta 7.3** · #1 (**permalink**) 06-15-2008, 08:58 AM

Well, a local diesel shop had their Dyno Day yeserday, and I plunked down my $50.00 to see what the old beast could do. I was pretty happy that I even beat out some newer Dodges

I'm not sure of the accuracy of the runs, since they ran the trucks up to Drive, or in my case 4th, at 40-50 MPH then started recording, and stomped on it, making each run 45 sec-1 minute, and just a single pull per truck.

farmboypowerstroke · #2 (**permalink**) 06-15-2008, 09:02 AM

wow great numbers

**SMKSTAX** · #3 (**permalink**) 06-15-2008, 09:05 AM

Nice numbers man!!

97powerstroker · #4 (**permalink**) 06-15-2008, 05:22 PM

great numbers but i think the tq seems low,just my opinion though,all that with stage 2's hpop and chip,thats cool.

**alberta 7.3** · #5 (**permalink**) 06-15-2008, 05:46 PM

I agree the torque seems low, I think they started recording data after the torque had peaked, giving it a low number. The guys running the dyno seemed only interested in "Big HP"

**Marty** · #6 (**permalink**) 06-15-2008, 05:51 PM

50 bucks for one pull?

FFR you can usually get 3 pulls for between 50-75 bucks.

However good numbers out that OBS!

**alberta 7.3** · #7 (**permalink**) 06-15-2008, 06:04 PM

Around here 50 bux is a deal, normally it's 150 and up

**Rob** · #8 (**permalink**) 06-15-2008, 06:08 PM

nice numbers bud. i need to get mine on a dyno. im real curious what it will do.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement