bad warm start - Ford Powerstroke Diesel Forum

 
LinkBack Thread Tools Display Modes
post #1 of 3 Old 03-03-2008, 04:46 AM Thread Starter
Compression Ignition Addict
 
Join Date: Dec 2007
Posts: 226
Thanks: 0
Thanked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Quoted: 0 Post(s)
Feedback Score: 0 reviews
bad warm start

I went to start my truck after being shut off for 10 hours and it wouldn't start. the starter was cranking over but nothing. i waited a few minutes tried again and it started but was super rough and then it died. so i waited a bit again and tried, it started but was really rough and then after a bit it smoothed out. i drove home about 20 minutes and then shut it off. i tried to start it after i shut it off and it fired up right away. Any idea's of whats the cause? Also i have been getting alot worst fuel mileage out of it recently.

1995 F250 7.3 turbo
3 inch dp into 4 inch exhaust
tymar intake, Isspro boost, pyro, tranny temp gauges
tow and go shift kit, DIY electric fuel pump system with fuel pressure gauge,bronco tank mod
kcm ss hpx line, stancor gpr, 203 thermostat, 03 starter
TWchip 6 postion daily,econo,tow,street,xtreme,highidle
Banks intercooler and pipe kit,Idm Mod,CCV Mod
Plant drive wvo kit(hotfox,vegmax filters,26fphe, vegthermmega and gauges for cooliant and wvo temp)
Dana 60 front axle swap
7.3TurboDiesel is offline  
post #2 of 3 Old 03-03-2008, 04:52 AM
Marine Raiders>Seals



 
najaf4life's Avatar
 
Join Date: Dec 2006
Location: Solsberry, IN
Posts: 7,120
Thanks: 4
Thanked 66 Times in 49 Posts
Mentioned: 2 Post(s)
Quoted: 0 Post(s)
Feedback Score: 0 reviews
I would say most likely your cps... have you ever changed your cps out?

RYAN
03 Excursion 6.0L

BPD,WPE & other odds and ends
najaf4life is offline  
post #3 of 3 Old 03-04-2008, 04:03 AM Thread Starter
Compression Ignition Addict
 
Join Date: Dec 2007
Posts: 226
Thanks: 0
Thanked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Quoted: 0 Post(s)
Feedback Score: 0 reviews
cps =cam postion sensor right. where about is it?

1995 F250 7.3 turbo
3 inch dp into 4 inch exhaust
tymar intake, Isspro boost, pyro, tranny temp gauges
tow and go shift kit, DIY electric fuel pump system with fuel pressure gauge,bronco tank mod
kcm ss hpx line, stancor gpr, 203 thermostat, 03 starter
TWchip 6 postion daily,econo,tow,street,xtreme,highidle
Banks intercooler and pipe kit,Idm Mod,CCV Mod
Plant drive wvo kit(hotfox,vegmax filters,26fphe, vegthermmega and gauges for cooliant and wvo temp)
Dana 60 front axle swap
7.3TurboDiesel is offline  
Reply

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Ford Powerstroke Diesel Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in









Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode



Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome