Donor F250 5spd

[yngbuck19]

Well if I sell the motor, axels, transfer case, e4od, PCM and IDM and whatever else take it to a junk yard or scrap yard I would hope to be able to have the whole swap of everything I need and get the 5spd rebuilt and good valiar single mass clutch and flywheel in it and come out even I will be happy as a clam. What do you guys think is reasonable price for the parts I don't need what's the going rates I only know what it all costs new I hope it sells fast

[BigFuel]

What's the IDM-xxx? I'm interested.

[terryknight]

keep the pcm. and yes buy it. always try and talk him down a bit. is it a 250 or 350 350 front axle has value the rear doesn't have much value and the TTB from a 250 has no value either.

[rolsmojave3]

Scrap here is $190/ton right now

[yngbuck19]

Big fuel I'd give you the number but haven't bought it yet

[ol_Blue97]

U will make out... just sell the parts at a reasonable price and dont try to get rich off them and they will sell fast

[terryknight]

where is the truck? frank wanna go halves. i could use a 5 speed for the 97. (OP this is more of a joke, you should buy the truck.)

[ol_Blue97]

^^^ sure, i could use some more parts laying around... split everything right down the middle... hahahaha, i will even have a nice trailer to haul it wed!

[yngbuck19]

Chuckatuck va private seller

[ol_Blue97]

road trip terry?? hahaaha.... serously tho, but it asap b4 its gone, i inquired about a 10' dump truck with 180k 4x4 dully a while back for 2500, (needed a trans) sold in one day, i emailed on day 2