Please Visit our Site Sponsors
|
Please Visit our Site Sponsors
|
 |
|
 |
 |
|
|
|
||||||||
 |
|
|
LinkBack | Thread Tools | Display Modes |
06-02-2011, 08:27 PM
|
|||
|
|||
|
factory alcoas
i have a 95 f250 that has a 89 f350 dana 60 under it. and i was going to purchase the factory alcoas for it. i understand that the bolt pattern is the same but would the back spacing be ok to clear the tie rod end or would i need to run a small spacer.. thanks for the help
|
| Sponsored Links | ||
Advertisement | ||
|
||
|
06-02-2011, 10:25 PM
|
|||
|
|||
|
Welcome to the ORG!
Check the Alcoa wheels site. I'm sure it's the same wheel for the F350 and 250.
|
| Sponsored Links | |
Advertisement | |
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
