diagram needed

mark121268 · #1 (**permalink**) 08-19-2012, 03:52 PM

hello to all hope i am posting in the right spot i need a diagram of the brake system on my 1995 e-350 with 7.3 power stroke cube truck my question is from the master cylinder the lines go under the truck towards the back but before it gets there the lines go into a steel block (rusted bad) and looks like some wires go in to it , i am hoping some one here will have a diagram with pics if possible. i try to figure it out by reading and this forum but when all else fails ask the pros

thanks for any help you can provide you have helped me before for the resonator question. hopefully you can again
i will take a picture of it in the morning and post it

**BigFuel** · #2 (**permalink**) 08-20-2012, 09:46 AM

I don't have a brake diagram but that block is the RABS (rear anti-lock brake system) actuator. Brake system is dead simple. What would you like to know and I'll try to help without the diagram.

mark121268 · #3 (**permalink**) 08-22-2012, 07:09 AM

thank you , that is what i was looking for the name of the part .again you guys are the best .

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement