problems with new o-rings?

johnorless · #1 (**permalink**) 04-12-2011, 04:19 PM

Hi there,
As I mentioned I just put new o-rings in my HPOP and now the ps won't start. Is there anything I could have done to screw up the HPOP when I put in the new o-rings?

**CHUCK** · #2 (**permalink**) 04-12-2011, 04:31 PM

depends on how much oil you lost in the process. May have gotten alot of air in the system...How may times have you tried to start it and for how long....

I know swapping injectors, draining the oil gallerys, it takes awhile to get the air out of the system...its recomended to have a battery charger close by due to drainning the batteries when tring to start afterwards.

johnorless · #3 (**permalink**) 04-12-2011, 05:04 PM

Been trying to start it for about 3 hours on and off haven't run down the batterys yet but I did loosen one of the oil lines and I am getting flow

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement