ALABAMA FROG WERE ARE YOU!?!?!?!?

[harley1rocker]

need your help bud! if you have time of course,subject is the 95 obs,im pulling the motor to do a refresh on it,valves, rings and num 5 piston needs to be replaced,the walls to that hole are scared but not that bad,just enuff to feel it there,my question is,will that hole have to bee bored over to say a .10 or should i go .20 and if i do will all the other holes need to be bored over? well then i would have to buy all new pistons,of wich i do not have the money,i do however have the money for the rings,do you think i could just hone the holes and redoo the rings?

[Jarrod B]

you have a pm