Join Date: Aug 2012
Location: Fulltime RVer
Thanked 1 Time in 1 Post
Mentioned: 0 Post(s)
Quoted: 1 Post(s)
Feedback Score: 0 reviews
Not sure if you're aware of these... Just thought I'd post, if not:
Highlights from TSB:
Issue: Some F-Super Duty F-250-450 pickuptruckvehicles equipped with a 6.7L diesel engine may experience an engine shudder with or without turbo flutter noise around 900-1400 RPM with steady throttle. The issue may be more noticeable at high elevation, high ambient temperature and/or when driving up a slight incline. The concern is not present during regeneration or while using cruisecontrol. Some vehicles that exhibit the concern may set diagnostic trouble code (DTC) P0299.
Service Procedure: 1) Check all continuous memory diagnostic trouble codes (CMDTCs). Are any DTCs present other than the P0299?
Yes - This article does not apply, refer to Powertrain Control/Emission Diagnostic (PC/ED) Manual and continue with normal diagnostics.
No - Proceed to Step 2.
2) Using the IDS, take a recording of the event. Enter data logger and select the following pids:
MAP_A (psi), MAF_A (g/s), EBP (psi)
RPM, APP1 (%), VGTDC (%)
3) Road test vehicle and duplicate the concern.
4) Make a recording of the event.
5) Review the recording taken and compare it to figure one located and the end of the article. Does the recording show MAF_A fluctuation with APP1 steady like the figure provided?
Yes - Replace the turbocharger. Refer to WSM section 303-04D.
No - This article does not apply, refer to PC/ED for normal diagnostics.
Some 2011-2012 F-Super Duty vehicles equipped with a 6.7L engine and built on or before 5/15/2012 may exhibit diagnostic trouble code (DTC) P0181. Refer to the Calibration Content for additional calibration updates.
Follow the Service Procedure steps to correct the condition.
Please run Oasis using the Vehicle Identification Number (VIN) to search for open Field Service Actions (FSA) and claim reprogramming updates against open FSA's when applicable. The latest level includes all previous enhancements released in prior calibration levels.
Reprogram the powertrain control module (PCM) and the transmission control module (TCM) to the latest calibration using IDS release 79.01 and higher. This new calibration is not included in the VCM 2012.5 DVD. Calibration files may also be obtained at Buy Motorcraft Parts Online | Official Motorcraft Auto Parts Site | FordParts.com.
NOTE: PLEASE ADVISE THE CUSTOMER THAT THIS VEHICLE IS EQUIPPED WITH AN ADAPTIVE TRANSMISSION SHIFT STRATEGY WHICH ALLOWS THE VEHICLE'S COMPUTER TO LEARN THE TRANSMISSION'S UNIQUE PARAMETERS AND IMPROVE SHIFT QUALITY. WHEN THE ADAPTIVE STRATEGY IS RESET, THE COMPUTER WILL BEGIN A RE-LEARNING PROCESS. THIS RE-LEARNING PROCESS MAY RESULT IN FIRMER THAN NORMAL UPSHIFTS AND DOWNSHIFTS FOR SEVERAL DAYS.
The Calibration Update Contains Improvement Actions And Enhancements To Address The Following:
False DTC P0181 (fuel temperature sensor A circuit range/performance)
Previously Released - Calibration Content
Included in IDS software release 74.03 and higher contained improvement actions and enhancements to address the following:
Calibration Content - Pick Up Truck (non-chassis cab) Vehicles Built On Or Before 3/7/2012
Runs rough/misfire during diesel particulate filter (DPF) regeneration
Calibration Content - Vehicles Built On Or Before 7/25/2011
False DTC P0884 (PCM/TCM power input signal intermittent)
Calibration Content - Vehicles Built On Or Before 5/31/2010
DTC P0134 O2 sensor circuit no activity detected (bank 1, sensor 1)
Calibration Content - Vehicles Built On Or Before 4/11/2010
DTC P0401 (exhaust gas recirculation (EGR) flow insufficient detected)
DTC P0402 (exhaust gas recirculation (EGR) flow excessive detected)
DTC P009A (intake air temperature/ambient air temperature correlation) if driven at highway speeds with a snow plow attached
Harsh/inconsistent transmission shifting during transmission fluid warm up
Improved shift feel for tip-in events at low speed or when coming to a stop
Calibration Content - Vehicles Built On Or Before 11/5/2010
Delayed manual upshifts from 1st to 2nd gear when in Select Shift mode while going down a grade
Harsh/delayed 1-2 upshift and downshift
DEF warning messages won't reset after refilling DEF tank with Key On Engine Running
Modified vehicles for rail applications, that will not re-engage PTO operation or speedometer inoperative after riding on the tracks with the front wheels off the ground
VSOUT signal inoperable from customer access circuits under dash
DTC P2463 or P246C (DPF restriction) and DTC P2459 (DPF regeneration frequency) - adds increased ability to perform manual regeneration at higher load values when performing system diagnostics
Calibration Content - Vehicles Built On Or Before 08/23/2010
False DTC P132B (turbocharger/supercharger boost control A performance)
False DTC P0299 (turbocharger/supercharger A under-boost condition)
False DTC P050E (cold start engine exhaust temperature too low)
False DTC P06EA (NOX sensor processor performance (bank 1, sensor 1)
DTC P249C (SCR time to closed loop) - improved diagnostics and reporting
DTC P249F (excessive time to enter closed loop DPF regeneration control) - improved diagnostics and reporting
DTC(s) and freeze frame data being erased in the PCM when running KOEO, KOER, Datalogger, Active Commands or any other guided diagnostics with IDS
False P0731 (gear 1 incorrect ratio)
False P0732 (gear 2 incorrect ratio)
False P0733 (gear 3 incorrect ratio)
False P0734 (gear 4 incorrect ratio)
False P0735 (gear 5 incorrect ratio)
False P0729 (gear 6 incorrect ratio)
Low speed/load engine surge
Abrupt engine shutdown feel
HP fuel pump knocking noise at idle
Delayed DEF level indication after refill event
Harsh/bumpy transmission upshifts/downshifts
Delayed/harsh transmission engagement feel between R-D and D-R shifts
Transmission gear hunting during speed control operation when climbing grades or climbing hills, particularly while towing
Erratic transmission operation after descending grades while in 1st gear
Flashes/delays of current gear indication when using SelectShift mode
Added Brake Over Accelerator (BOA) feature - reduces engine power during off-idle driving when both the accelerator and brake pedals are applied simultaneously
Added SelectShift memory feature so the SelectShift gear display comes back on whenever going back into drive if the vehicle was turned off while SelectShift mode was still activated
Added engine protection feature from overspeed when descending long grades while towing and in manual gear ranges (forces transmission upshifts at 4000 RPM)
Increased torque - during hill assist operation - (see Owner Guide for additional system operation)
PTO operational enhancements - (applicable to vehicles equipped with optional PTO)
- Automatic secondary electronic idle controller (SEIC) turns on at engine start if the switch is in the on position
- Engine coolant temperature to operate PTO lowered to -7 °C (+20 °F)
- Improved RPM control with SEIC controllers
2014 F-450 PLATINUM
2014 Dutchmen Voltage 3200 5th Wheel Toy Hauler
2007 Honda GL1800A Gold Wing
Last edited by ATCguy; 08-14-2012 at 07:21 AM.